Pay attention to the suitability of choosing ppe

Question 1. What can I do if the battery cannot be stored?

Solution:

1, please confirm that the fuse, power switch, power line and voltage switching switch caused by the problem.

2. Check whether the transformer has AC110/220 input and AC18V output.

3, the battery on the board to remove the PIN, measuring the machine version of the charging voltage is about 7.2V, if not enough, please check the power supply related circuits.

4. Check whether the diodes near the PIN input terminal of the transformer are normal.

5, replace the battery.

Question 2, how to solve the poor sensor identification?

Solution:

1.Static quantity method: Use the three-use ammeter to measure the E+ to S+, S- (or E-to-S+S-also) resistance of the sensor, and the error is generally 0.5. Above Ω, compensation is required. If the error is too large (more than 2Ω), it is recommended to replace L/C.

2. Dynamic volume method: Connect the sensor wiring correctly to the motherboard, and use the digital voltage meter (more than four and a half or more) in the DCV file to measure whether the S+ voltage is equal to the S-to-ground voltage (preferably 0 error) If it is not equal, sensor compensation is required.

Problem 3, angular coupling adjustment (single sensor) method?

Solution:

1, first weight correction.

2, with a full load of 1/3 of the weight of the weighing pan to see its display value.

3. Press the zero on the side with the lowest value of the scale in the 1 to 4 corners of the file. (When grinding the scale for the first time, test the force with a small force test to avoid damage to the sensor.)

4. Repeat 2~3 actions until the center of the weighing pan is within ±1 jump from the center, and then do weight correction.

5, if the error value of the scale value of the pan is too large, and after the scale is still too large, it means that the sensor has failed, or the method of grinding scale is wrong.

6, when grinding scales need to pay attention to the sensor specifications, the lighter the full load, the lighter the grinding force.

House Appliances Solenoid Coil

The category of Solenoid Valve Coil used in home appliances Solenoid Valve, such like water purifier solenoid valve, coffee maker solenoid valve, washing machine water inlet solenoid valve, Steam Iron Solenoid Valve, ro solenoid valve, refrigerator solenoid valve, and so on. 

1. Solenoid coil range in hole diameter from 5 mm to 28 mm, more bigger is available.

2. Common AC and DC voltages (6V DC, 12V DC, 24V DC, 36V DC, 48V DC, 24V AC, 110V AC, 115V AC, 220V AC, 230V AC, 240V AC) are all available, others can be customized.

3. Many termination options are available.

4. Using high quality wire which has UL approved;

5. Using high quality permeability magnetic material which contain low carbon

6. Using high quality housing material like PA66, PBT, PPS, BMC and so on.

7. Insulation class can be B, F, H, N, C;

8. Protection class can be IP65, IP67 & IP69K;

Coffee Machine Solenoid Valve Coil, Steam Iron Solenoid Valve Coil, Dryer Gas Valve Coil

NINGBO BRANDO HARDWARE CO.,LTD , https://www.brandopneumatic.com