Operation of driving electric washing machine
1? Washing machine before operation Check the machine wires? Are there any damage, the machine has no fault?
2. Check the connecting box of the recovery tank. Open the upper cover of the recovery tank. Check the connection between the suction pipe and the recovery tank. Check whether the components are connected properly and seal well. Then check whether the suction pipe and the recovery tank are connected correctly and sealed.
3. Install the scrub brush or needle holder? Place the scrub brush or needle holder flatly under the machine cleaning plate in the middle of the alignment. Face up with the fasteners. Step on the pedal and gently lower the cleaning plate. Wash the floor brush or the seat of the needle seat? Then press the lower right side of the control handle and hold the switch.
4, adjust the suction cup? Put the suction cup handle? Lever? Let the suction disk landing? Adjust the left and right walking wheels to the same height on both sides of the suction cup? Adjust the suction cup adjustment knob to the angle between the absorbent tape and the ground into 45 degrees.
5, start work? Start the total switch to start the washing switch to start the suction switch? The cleaning brush starts to rotate? The suction cup starts to absorb water.
6, open the water valve lift rod to adjust the supply of cleaning solution? Cleaning solution should be able to normally wet the ground but can not flow outside the antifouling rubber? The amount of cleaning solution supply should also depend on the type of floor, cleanliness and machine The speed of progress?
7. Start the work? When the floor washing machine is working, walk to the right, turn left, turn the direction of the wall, and guide the wheel when it is against the wall. When cleaning the floor, it must be carried out in order, so that it is not heavy, or it will cause cleaning. not effectively.
8. When the water in the recovery tank is full or filled with fresh water, you should immediately open the drain cap and empty the recovery tank.
9, when the work is completed or after the battery is exhausted? During the lunch break can be charged?? First close the water switch, wash switch? After closing the main power? Remove the scrub brush or the needle seat? Remove the battery connection cable. 10. It is recommended to clean the suction cup, needle seat, or floor brush before washing off the floor every day? Wipe the outer surface of the washing machine.
Aluminum Profile,LED Aluminum Profile,LED Flexible Strip
LED Power Supply Co., Ltd. , http://www.szledstrip.com
برچسب: ،